iConverter
®
iConverter 4Tx
4-Port 10/100BASE-TX Managed Ethernet Switch
The iConverter 4Tx 10/100 Ethernet Switch module is a member
of the managed iConverter product family. The 4Tx provides a
compact 4-Port 10/100 Ethernet switch that is expandable
across the iConverter 19-Module, 5-Module and 2-Module
chassis backplanes, as well as being supported as a
standalone switch with the iConverter 1-Module Chassis.
The iConverter 4Tx UTP ports feature 10/100Mbps, Half or
Full-Duplex and auto-negotiation with both hardware and
software controls. Hardware control is available for two ports
while all four ports are under software control for these features.
RJ-45 crossover support eliminates need for a crossover cable
and facilitates connectivity to different types of network
equipment. The 4Tx crossover switch is supported on Port 1.
Ports 2, 3 and 4 support an automatic crossover detection
mode. The 4Tx also features two Ethernet backplane ports to
provide connectivity to adjacent modules for network expansion
and for in-band connectivity to an iConverter Network
Management Module.
„
„
„
The iConverter 4Tx Managed Ethernet Switch supports
10BASE-T or 100BASE-TX on four UTP ports
Enhanced features include Port VLAN, Port Access
Control and MIB Statistics
4Tx enhanced features include Port VLAN which allows
complete control of traffic flow between a module’s ports, and
Port Access Control which incorporates remote enabling and
disabling of each individual port. The 4Tx supports reporting of
MIB statistics that are available for 32 variables per port, reporting
a wide range of real-time packet statistics to provide
performance and operational monitoring.
Multiple 4Tx modules can be installed to expand the
port concentration in a single chassis
„
„
Supports Half or Full-Duplex and auto-negotiation
RJ-45 crossover support eliminates need for
different cables in connecting to various devices
„
„
„
Ethernet backplane ports for connectivity to adjacent
modules
Management is available with the addition of a
management module to the chassis
SNMP management via NetOutlook™ provides real-time
port and module information, remote parameter
configuration and trap notification
„
„
„
Conforms to IEEE 802.3, 10BASE-T and 100BASE-TX
specifications
iConverter 4Tx modules are hot-swappable and can be mounted
in a 19-Module (2U high) or 5-Module (1U high) rack-mountable
chassis (19-inch or 23-inch) with any combination of redundant
AC, 24VDC or 48VDC power supplies. They can also be mounted
in a 2-Module AC or 18 to 60VDC powered chassis, or in a
1-ModuleAC/DC powered chassis.
Modules are hot-swappable in 19-Module, 5-Module,
2-Module or 1-Module chassis
Lifetime Warranty and free 24/7 Technical Support
|