S
P
E
C
F
I
L
E
Ceiling mount bracket for low ceilings
ET-PKE1000S
Description
This ceiling mount bracket is to be used when mounting home cinema projectors to the ceiling.
Specifications
Vertical correction angle:
Horizontal slant correction angle:
Horizontal turn correction angle:
Dimensions (W x H x D):
Weight:
+5°, -15°
10°
5°
468 x 200 x 191 mm (18-7/16˝ x 7-7/8˝ x 7-17/32˝)
1.9 kg (4.2 lbs)
Weights and dimensions shown are approximate. Specifications subject to change without notice.
Parts
Attachment plate . . . . . . . . . . . . . . . . . . . . . . 1
Washer-fitted screws (M4 x 8) . . . . . . . . . . . 10
Wire rope . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Flat wire clip . . . . . . . . . . . . . . . . . . . . . . . . . 2
Clamp tube . . . . . . . . . . . . . . . . . . . . . . . . . . .2
Projector mount bracket . . . . . . . . . . . . . . . . 1
Safety fitting A . . . . . . . . . . . . . . . . . . . . . . . . 1
Safety fitting B . . . . . . . . . . . . . . . . . . . . . . . . 1
Safety fitting C . . . . . . . . . . . . . . . . . . . . . . . . 1
Caution:
•
•
•
•
•
All mounting work must be done by a qualified technician.
Ensure that the mounting (ceiling) area has sufficient strength.
Read the enclosed mounting instructions carefully before starting the mounting procedure.
When the system is no longer to be used, have a qualified technician promptly remove and dispose of it.
Do not use a power screwdriver or impact screwdriver to tighten screws. A torque screwdriver or similar tool
should be used.
Dimensions
Illustration shows the ET-PKE1000S attached to
the PT-AE2000.
Attachment plate
Ø9.5 (3/8˝)
Attachement plate
Ø8.5
(11/32˝)
181
(7-1/8˝)
PT-AE2000
104 (4-3/32˝)
130 (5-1/8˝)
150 (5-29/32˝)
65
unit : mm (inch)
NOTE: This illustration is not drawn to scale.
(2-9/16˝)
As of September 2007
< 1 >
|